Has anybody had any success setting a DCC-EX command station to a static IP. I am still plagued by the inability of this feature to work. It is included in the code but does not work!
I couldn't get a mega that has WiFi on board to work in either mode but using a Makerfab WiFi shield on another mega got it to work in AP mode right away.... http://1fatgmc.com/RailRoad/DCC/page-1.html Haven't tried what you are trying to do though. If you haven't done it I'd ask the question with the Discord Group..... https://discord.com/invite/PuPnNMp8Qf One way is use the Support (Open a ticket) option. They are usually quick to respond, Sumner
The parameter in config.h to define a static IP is applicable to Ethernet; it is not used for WiFi. To get the same IP address each time, reserve the IP address in your router. Probably easiest to let the CS connect the first time, so the router will have captured the mac address, etc., and then reserve that IP. ---------------- a second option ------------------ Various WiFi settings can be defined using 'AT' commands. AT commands are entered directly into the serial monitor in real-time or as setup commands in the mySetup.h file. https://dcc-ex.com/reference/software/command-reference.html#wifi-at-commands And if you use the 'AT' commands, you may need to add #define DONT_TOUCH_WIFI_CONF https://dcc-ex.com/advanced-setup/wifi-config.html#define-dont-touch-wifi-conf Note that even when you define the static IP, you will still want to reserve it in your router.