https://www.youtube.com/watch?v=7IvfgXoZp2M plowing snow on the Argentine Central.
Roof had some patching that needed done and the cupola needs a lot of work. The siding needed to come off to check on the status of the frame as...
[ATTACH] The general consensus we reached after removing the siding on the side of the car that was original to the C&S was that the cars weight...
[ATTACH] A end of the caboose with the siding removed. The paper hanging in there actually shows how good of a shape this caboose stayed in, that...
Hello All I'm a volunteer with the Colorado and Southern Historical society, we've been working on restoring bobber caboose 1006 in Silver Plume,...
Boxcab, it might be, I'm not entirely sure. It's one of the old buildings from the old pikemasters layout so I can ask around.
I'll put that out to the narrow gauge guys, we have done a train ride video on the standard gauge with a gopro, but I doubt that would fit on the...
[ATTACH] Shoving the string into the yard. [ATTACH] Now tied down in Durango yard, these cars will be loaded onto standard gauge flats for...
[ATTACH] 151 moves in to get the string of cars. [ATTACH] 151 moves the string of cars up the yard lead. [ATTACH] Bobber Caboose #1025 wasn't...
[ATTACH] As per the train orders received at the upper wye, we pass extra 473 in the siding at Durango. 473 is waiting for an outbound passenger...
[ATTACH] 345 passes C&S mogul #17 at the engine shops. 17 was supposed to pull this train but had to be sidelined for a mechanical issue....
[ATTACH] Emerging from the tunnel on the west side. [ATTACH] The crew decided to stop here for a break while the retainers were turned off....
[ATTACH] Over the high bridge. This bridge is scratchbuilt. [ATTACH] Normally during operations, we take a left and go through that tunnel, but...
[ATTACH]Extra 345 pauses at the telegraph office at the upper wye to pickup train orders. Two orders received; proceed to Durango, and meet extra...
A string of C&S cars on the layout was recently sold to a new owner in the Denver Area, and rather than just removing the cars from the layout, I...
[ATTACH]BOOOOOOOOO for the bad puns :cool:
https://www.youtube.com/watch?v=Qz1uoYBSqpQ Running D&RGW 346's air pumps off air in the shop to test them after some work was done on her...
MTH doesn't have a separate line for cheaper stuff, however the F3 they produce is considered to be a starter set engine. It does not have the...
Keith, the rolling stock doesn't hit anything, but the camera is wider than the car and does clip some close rocks as it goes around, hence the...
[IMG] The bottom of the shay's crankshaft does come a little bit close to the switch machines and the ballast in spots...... [IMG] I didn't...