Many times there are browser updates that mess with your access. Delete old cookies, reboot the browser and retry access to the forum.
Also if you are using white glue, add just a tiny bit of salt to the water and isopropyl alcohol and mix it well before you add it to the glue for...
The only downside of ESU decoders with Decoder Pro is the necessity to use Read All Sheets on the Roster Entry tab to read the "setup" of the...
The answer to all of the woes of BLI sound is SoundTraxx Tsunami 2.
Let's not forget Frisco.org as a huge resource for Frisco History and Modeling.
It was all resolved shortly after Mike's last post.
There is a rumor to be on the lookout for some real heritage units.
Martin Oil Co. and Simpson's [ATTACH] [ATTACH][ATTACH]
That is some very nice modelling! I haven't seen better in any scale.
CV116 controls Engine Exhaust sound on Tsunamis. Bit number 5 set to o makes the engine remain quiet until dialed up and speed step hits 1. Note...
Here's a look at my completed installation with a new Soundtraxx Econami ECO-100 Diesel decoder. Note that there is enough room left using the...
Bits 0 - 3 of CV116 sets the notch rate; how many notches per speed step. 0=Manual notching based upon F9(up) and F10(down), decimal values 1 -...
If you are using a cell phone speaker element and are not using a sound chamber, you will not get very much volume and the sound will be lacking...
Consider using 3/4" plywood ripped into 3" or 2 1/2" widths for all structure. It's what we use here in the KC area on everything from small (24"...
I just received the Diesel Era issue (May/June 2000) from Withers Publications thanks to Paul himself. The air line routings in their...
...and provide some real class.
Dear Ike the BN Freak, there has been lots of discussion about the Torpedo-tube GP35s on Frisco.org over the past two months. If you would have...
If you want info on Frisco Torpedo Boat GP35s, check out www.frisco.org for a modeling thread including rooftop piping drawing:...
How did the trestle rebuilding go?