They do. I sent a DT400R off two weeks ago to be upgraded to a DT402D.
In some ways, the new DCS210 based set is more than a Chief system. In others it is less. DCS210 has 100 slots. DCS100 DCS100 has 120 slots....
$60 is a decent price for that DB100+ booster. It is a very early Digitrax Challenger DCC system BUT it is not loconet compatible. That being...
Programming on the main is fine for just about every programming step. Changing address can get a bit hairy. First you need to clear all other...
The added 12 - 14 volt power supply mentioned in the UTP manual is to power throttles when they are plugged into the panel. It does not add power...
That is normal. The throttle doesn't know the system is turned off. DT400R is simplex so it just sends to the UR91 when unplugged. As long as the...
Install a decoder in the B unit. No wires to run between the two and you can speed match each unit with its own decoder.
Guessing you have an NCE PowerCab. Unfortunately the Powercab uses the cord as a power supply wire to the track. The factory supplied cord is...
RJ12 is 6 pins, 6 conductors. RJ11's are 6 pins, 4 conductor. The size of both is the same. You want ones that are marked 6P,6C. Both types have...
If the sub bus is not long, termination should not be needed. Long being 25 feet or more.
Here's the specs for a DB150. http://www.digitrax.com/static/apps/products/command-stations-boosters/db150/documents/Spec%20Sheet%20DB150.pdf Your...
BTW, Bachmann's system gets the NMRA conformance warrant because everything it does complies with NMRA standards. It doesn't have to do everything...
Try programming the address again. This time after programming, remove the engine from the track then place it back on. don't worry, you won't...
The two rear screws are for track popwer. They should be connected to rail A and Rail B from booster or track. The center solder dot is for a DC+...
To answer your original question... Yes, you will need a power supply for Digitrax and NCE 5 amp + DCC systems. Both of those companies include a...
Is the UP5 installed properly? Many a UP5 have been inadvertently installed with the track power screws to the front because they fit perfectly....
DS52 will handle two Tortoise machines. It's in the manual and I've been doing it for years....
Need to know what type of Lenz decoder. Silver and gold support CV5 and CV6. Older model Lenz decoders do not. So a speed table is required on the...
Program a new address and run it. Martin Myers
The dot must be on solid. Blinking means track power is in "suspend" mode. Track power is on so lights will light but no command packets are sent...