It all works quite well. You can use a reversing module, or use the turnout at the bottom to control the polarity of the reversing section
Where there is a junction or crossing a route needs to be set for a train to proceed, and in this case all signals will be at stop until the...
Some high efficiency LEDs, especially red and white ones (and blue and true green should you need it), should be able to give a reasonable light...
It all depends on what the semaphores are and why they were left:- 1. If the semaphores were mechanical there would probably be a cabin at either...
I don't use CATS or the Bruce Chubb hardware, it is not really required any more to create a good panel, but it can still be used and there is a...
That 1927 signal system is a really nice and easy one to implement - even if it does have a lot of heads for not many aspects. I like the way that...
With UK outline you will want to hear the sound of English Electric engines. 1000HP Class 20 (Choppers), 1750HP class 37 (Tractors) and 2000HP...
Yes, UK loading gauge is much smaller than continental gauges, so the 4mm scale stock will generally run on H0 layouts. This small loading gauge...
Hi Caxu If you are starting now in 00 you will have a really good choice of ready to run, with relatively little overlap of models across...
Looking at the Signalist website, it is the NORAC generic configuration that has all the correct aspects which is shown in the manual, but only...
If you are using JMRI you can ignore any automatic route signalling that the SE8C does and just drive the heads directly from heads in head...
Yes, it will probably take quite a lot of modellers license to pretend that those slips are #18! Triple head masts it should be.
Hi Kaustav I think that it should all be a bit simpler than what you have in your diagram. NYC is a speed signalling system (not route signaling)...
The advantage of electric in the early days was higher availability and high power for mountain climbing. It all comes around again and the...
I would be inclined to use a 4-pole on-on-on toggle switch to make life easy, but you could use a 3-way 4-pole break before make rotary switch....
There are several servo point controllers available now, especially DCC ones. I like the Signalist SC2 which has integrated frog switching for...
It is audio only, and looks to be part of a series of 50 programmes. If it is allowed outside the UK it should be playable in a HTML-5 capable...
DCC Concepts do some nice switches which should give an old fashioned signal box feel:-...
It looks like you have got the servos working, so you are well on the way to appreciating the low cost and slow motion capabilities of servos....
Since you are using LEDs you might like to make your own decoder. The low power DIY function decoder at dccdiy.org.uk which you can make yourself...