Thanks for the reply, I'm not sure why I didn't get notified of your post but I've been out of trains for the past couple years. Unfortunately...
Parallel, not series! If you put them in series then they add together (470*3=1410 ohms), without increasing the wattage. Right, in my setup I...
Gah! I was thinking each additional resistor cut the value in half, but yeah you're right, it's just a simple division. I'll just stop talking...
I would expect fairly similar values, so I too am uncertain why the values in that other post are so extremely different. The other post is...
Ah crap, you're right. I looked back at it a little closer and I did in fact describe it wrong! OK so after you lift the L298D pins off the...
The L298D boards that you typically find, which look like the one in my image, do not have current-sensing available. However the L298D itself...
An H-bridge can be used to run different types of devices, depending on how it is used. In our case, we're running a simple DC motor so the...
Most of the ESP32 boards should work with this project, but what you use depends a lot on what you are comfortable with. The Uno boards that...
If I remember right, there were also issues using the original aurduino motor shield board that could be fixed by cutting some traces, but an...
Well here's a compile error for you... I disabled #include "Config_LCC.h", and get a bunch of errors stemming from this one: In file included...
Ah ok... Since the code I installed last night identified itself as 'Command Station' instead of "DCC++ESP32' and the whole structure of the code...
I pulled down the current master code last night and just uploaded it to my ESP32. I have motor control over my loco, however as with the...
Ack how did I miss that whole folder? OK thanks! I'm assuming you are storing the config in EEPROM space? My concern was where I blow an ESP32...
I'm looking back at S88 again just to test it out, and one thing I'm noticing in both the old and new code base -- it talks about needing a data...
So is the new code base still going to support the original ESP32 with the variety of hardware options or are you only going to be supporting the...
Wow ok I'm REALLY out of the loop here. So is the new code base fully compatible with the DCC++ESP32 code I already have loaded up? I'm assuming...
Hey folks, been a long Summer but I'm trying to get back into the trains again. So I left off with getting ready to set up another arduino for...
William -- the design is based around an ESP32 chipset which already has FCC approval and plays very nicely with existing wifi equipment. Check...
Right, if I was using a prebuilt board with a regulator on it... This project is migrating towards using the bare chips for a minimal board...
Just wanted to post an update that I haven't forgotten about this project, but I did get sidetracked. I have a new 3D printer (Ender 3 pro)...
