The NMRA DCC specification says the maximum voltage between 22v and 27v is acceptable, depending the scale you're using. The KA devices use...
I had decided that saving the granularity ot the state level wouldn't be an issue in the real world, because if one of the state machine status...
Thanks......I should have it installed in my new club layout in some months, but that's out of my hands as far as timing is concerned, as we're...
https://www.youtube.com/playlist?list=PLrA2wHV7HSm3lpWqyi4QQHHDVMjsbAy6n
It's more than a proposal....it's real, and in my case, I've had it functional for 5 years........unfortunately, I was not happy that the IR...
What's different about your detector design? I use TSSP4038 sensors that use a 38KHZ reference, and reject anything else. There are MANY similar...
You adjust each loco speed in settings for each decoder, assuming the decoders you have support that.......some inexpensive decoders don't have...
When I was trying to resolve the memory issue, I initially would save the current block count periodically. But, I was never satisfied, as there...
The original detectors were a 5mm IR source at 38khz and 2 TSSP4038 IR detectors mouinted as close to each other as possible. The new system uses...
I re-designed the system to use fiber optic cables (cheap from Asia) in order to make the detector parts fit between the rails, so they ONLY count...
I'm pretty sure that DCC-EX uses NO JUMPERS on the standard motor driver board, and 1 jumper when you use DCC++.
Besides what was already said, JMRI can, when used with Engine Driver SW on a smart phone as a throttle, allows you to label each function button,...
I'm fabricating various light board replacement PCBs to simplify DCC installations, and I need to determine the mounting holes to attach them to...
Yes, that works just fine, as I've already implemented that exact function. I use RS485 to transmit the DCC & an Enable signal to remote IBT-2...
You don't need to stop the train as long as the switch is made quickly......remember, the DCC signal is also the power for the loco, so if you...
Good news.......take as long as you need, no need to hurry. How many of the kits have been spoken for, or basically, how much interest has been...
As far as the MD LEDs, just a simple hole in the case would suffice. Concerning the Mega LEDs, specifically which LEDs are you concerned about?...
Since I don't have a TTG0 version of the ESP32, I was surprised to see the pigtail and antenna for the wireless stuff. Seems to me that you...
You need to be on the MAIN for a loco to respond to the throttle commands. I setup my program track withe DPDT switch so I can switch that track...
Mike: Is this part equivalent to what your TTGO is? This has a battery input and something to an external battery charger....
