http://yamorc.de/products/?singleproduct=1247
Depending on the interface connection settings in the Connections tab.
Try recalculate CV29 and reprogram it. I had in the past the odd occasion where it did funny things with the address. Have you checked if the...
Sounds like a missing driver, depending on the error message that is with the warning triangle. You probably need FTDI driver for the USB chip on...
https://www.esu.eu/en/start/
The orange wire is sort of indicator some of the wires is ripped out of the decoder. Originally the 6 pin socket is in the main body of the loco...
Try and change CV 29 to include long address (calculators online). Sometime it like to stick to short address. If you are programming manually...
To make changes to your decoder's CVs, all you really need is DeoderPro from JMRI. You either switch a button on or off, or replace a value and...
Yes, it should go back to the sound project's original values.
The voltage drop with a full rectifier is 1.4 v and half with a half rectifier circuit. Using a reed switch, current transformer, infra-red or...
One way to make it more sensitive is to increase the loops thought the transformer and the loops also has to be reasonable tight around the...
ESU has software that works with their Lokprogrammer. Basically the same as DecoderPro, different layout and tied in to their Lokprogrammer. If...
You only need the ESU programmer if you want program a new or update a project on the sound decoder. You can use their programming software...
You'll find the manual on their web site (http://www.esu.eu) under downloads. Most of their sound projects, including for other vendors, are also...
On some of the Loksound V4 sound projects they have this proviso: Make sure that index CV31 is set to 16 and index CV32 is set to 1 before...
See page 78 of the Locsound 5 manual, the second ' i ' and the table to the left of it. For some reason the lights functions are duplicated. And...
From the manual and KB articles sounds straight forward. Install driver, software, plug in PR4 using USB, and plug in power only for sound...
Is the 'OPS' LED on? Not to clear in the photo if it is on or off. The yellow power button in JMRI is an indication that is has problems...
Build Your Own Quad Servo DCC Decoder – Part 2 : page 9: Reading and writing of CVs values via a programming track (Service Mode) can be done...
The set up of short & long address is one of a few things setup in CV29. Check the manual what is should be for long address. Sometimes it just...