Many thanks!!
Hi I'd like it to include some rocky desert scenery, and a freight yard. Locos would be diesel. I'd appreciate any ideas, suggestions. Thanks,...
Hi There was a site where you could control a N-scale layout from your browser. They were a couple of trains with some switches. You could also...
What a successful project this DCC++...I've been using it for years. I added a few mods to the original code because I send string commands for...
Hi: Everything runs fine until I want to use my cellphone to control the locos. I installed JMRI in a "true" Windows 7 and the wifi throttle runs...
I had no problems reading the CVs with JMRI on the Paragon switcher.
Instead of using push buttons, you should use switches, they hold their position. if you use a push button, instead of commanding the servo...
Hi: I've seen ballast, of course, not only under the sleepers but also among the different tracks. The workers can be seen walking on the...
Kind of!
Hi: I want to add the passengers station to a Durango & Silverton-like tourist service included in my HO layout. It's just a 2-8-0 and 3...
It is offline now, isn't it?
Hi: I will add buffer stops to the yard. It is an American yard belonging to D&RGW. Diesels run here. Which one of these (picture) should work?...
FIXED. During one of my tries, while the programmer was trying write CVs (to no avail), I took the loco from the rails for 1 second and put it...
Hi: Suddenly, a Bachmann 2fn decoder ceased to work. It kept is address as it responded to the light on/off command, but no movement from the...
Excelent!! Many thanks! R.
Thanks, I managed to do it by carefully inserting a flat screwdriver.
Hi, I need to identify which is each pin. No socket available here. The manual does not detail the layout (it only tells the 8-pin socket...
I just bought this one second hand (looks good) and want to convert to DCC. But I can't find any screw or hint about disassembling the unit, i.e....
Looks like here are the plans, but unfortunately he ST-244 is not included, though there is a ST-44, Curved Turnout, Right Hand, but shorter. Is...
Thanks, but I didn't find any plan with the ruler included in order to properly print it in 1:1 scale. I was looking for the ST-244. I have some...
