This is very simple. Just jumper pin 12 to both pin 8 as well as pin 7. I have a switch which sets eight back to 2 when I need prog. David
Larry, The Pololu Current Sense is hard wired into the board. There is nothing you can do to change it either on the board or in the DCC++...
That brings up another question that I saw in another thread... why not reprogram the "B" side (an apparently spare 3 amp motor controller) for a...
Matt, I have a Bachmann GP9 with sound that runs great on both DC and DC++ with JMRI. Every thing works. DC ability can be turned off in CV's. David
Before I discovered this thread and one other (that I can no longer find) about adding a resistor/resistors, I returned a little 0-2-0 Tank...
There have been many questions here concerning using Gregg Berman's Controller to make one's own layout diagram and control it. Go here:...
Actually, I think this can be done with some jumper doubling and header pin bending. I've already changed my Pololu into a two Main output system...
Is it egomaniacal to quote one's self?:LOL: ....well one of my web sited is www.jennex.me and the other is www.DavidJennex.rocks, so I guess I...
I'm finally getting around to setting up an HO layout after being out of the hobby for years and years. Final size will be 10 by 20 feet walk in -...
Every blog should have emojis. A smile goes a long long way!:) Most of us when speaking to each other face to face speak in generalities, letting...
Scott, Your suggestion above is the crux of what I want to do. Bear in mind that the "Programming" terminals (terminals "B" as Gregg Berman...
Craig, As a matter of information, Gregg hasn't been on here for over a year. I have no idea where he's gone. I know he has or had a web site but...
Yes, but to stack another without jumper mods would provide two mains and two progs. Thanks for the reply. David
Hi All, Let's say I want to use an Arduino Mega with a Pololu MC33926 motor shield and I want both outputs to be Mains - no Programming tracks...
Hi All, Let's say I was using an Arduino Mega and a Pololu MC33926 motor shield and I wanted both outputs to act as Mains - no Programming track...
