hi, put two 0.2ohm in parallel
https://www.jmri.org/install/Mint.shtml
All good. I'm between 1 and 4. I vote 4
welcome back
type in search DCC++ or https://www.trainboard.com/highball/index.php?forums/dcc-electronics.114/
IMHO to keep things simple the DCC++ CS has to be only a CS connected to JMRI or to a throttle and the track. No sensors or accessory decoders...
I agree, is something like the uniting of fundamental interactions in physics. I'll try to explain this with a chart.
I requested access to this spreadsheet. I would like to have a read only access. Thank you
(y)(y)The documentation is a challenge too with a lot of work. Its a pity so if so much work cannot be used because of lack of documentation.
the cars look nice too:ROFLMAO:
Welcome Noted :). Electronics engineers involved in the hobby are invaluable.
Erik, Keith if I will have any circuit, you MUST design the board:)
it works
https://www.infineon.com/cms/en/product/evaluation-boards/dc-motorcontr_btn8982/...
for 2$ from ebay or aliexpress digital ammeter voltmeter + 1$ bridge etc. on the other hand, yours can't be lost:LOL:
cca same price...
New kid in the block https://www.infineon.com/cms/en/tools/landing/infineon-for-makers/arduino-shields/ DC Motor Control Shield with BTN8982TA
The arduino motorshield has a max drop voltage of 2.6V. What is the value of the track voltage? Don't raise the dc input voltage to the shield...
@drken, hi, So the problem is that there is a conflict between the two libraries(timer interrupt handling?). I'm saying this because my first...
Just curious, on what machine and os runs the jmri?
