Bts with 5a poly fuses. Sent from my SM-N976B using Tapatalk
Same as I'd have to anyway for the Prog track. Can I use the same inverted signal that feeds into my ops h bridge or would I have to make a fresh...
That gives me a thought. Could I use the spare second channel on my l298 to generate a second ops signal for the lcc bus? Sent from my SM-N976B...
Thanks Any suggestions as to an alternative for them? Sent from my SM-N976B using Tapatalk
Hi Atani, I've been looking at the schematic, and seems all of the parts are SMT only, so I've been looking at substitutions for TTH/DIP...
Do you have a circuit diagram for that please? Cheeky request I know... Sent from my SM-N976B using Tapatalk
The bottom connectors, just to confirm, that's two rj45 for lcc and a micro sd reader? I presume that the two lcc connectors are run off the same...
Merg canusb4 work? Sent from my SM-N976B using Tapatalk
How do I sort out a physical connection? I've got the basics for the CS side, but I'm not clear on what I need to do on the computer side. I've...
What's this and how do I do it? Sorry, not overly knowledgeable on the variety of rail technologies available. I'll come back on other points...
So I tried a different 'track' today. Overnight I realised that the Prog track might not be sorting because the l298 that I have might not like...
So we're turning on fine, I've set up to connect to an existing network, all is fine, setting the fixed ip address fine, jmri connecting fine....
Great... Killed/cooked my board somehow. Possibly too high a current draw somewhere, or the screen tried to play 5v with it. Either way, I've...
Found it. A little google searching shows that I was flashing incorrectly (ooh err Mrs). Turn board off with switch. Plug in USB. Hold boot...
I appear to have made an error in the command - I didn't need the brackets around COM7. However, still won't connect.
Device Manager is showing the USB to UART bridge as on COM7 VSCode identified it as COM7 as well. And Arduino ide. VSCode failed to connect to...
Success on the build. Now to flash.
Is this any better?
So close... I reinstalled idf so that everything was outside of the Windows directory, and made the amendment to the HC12 code. What now? And...
I specified Pin 27 TX and Pin 35 RX, and didn't make any other changes here.
