@FlightRisk I cannot find the file mySetup.h you talk about in the commandStation-EX zip folder, where do I find it?
@FlightRisk How to adjust the prog power out?
@FlightRisk Sensors-late issue solved, it was my fault on RocRail setup. I notice that locos on program track are moving a bit on read/write...
Thank you @FlightRisk I tested the sensors on all usable pins and it worked fine. However, I noticed a ~1sec delay in the response to the ON/OFF...
Thanks Ash. I still think that a full explanation should be given in the instructions on the dcc++ex webpage about reserved pins on MEGA cards....
Ok, got the point. Anyway using Arduino IDE to compile and upload to the board some more actions are requested: - Change the unzipped folder name...
Hi and happy new year to all. Maybe i missed something, tried the installer at https://github.com/DCC-EX/exInstaller/releases/tag/v2.3.1-beta.1...
Thank you very much schufti! in few days I will download the last DCC++EX code and test tracks and sensors. Will write a report for sure.
Hi all. As title says, it is maybe an old question. I'm experiencing a strange behavior of DCC++ While testing and regulating current sensors...
Lost image of the scheme here: https://drive.google.com/file/d/1ABcmLa-juqJXFVQx6NRImhvbL1dKRTS_/view?usp=sharing
I took these current sensors https://www.ebay.it/itm/5A-20A-30A-Range-A...E-/173585256771 in the version "ZMCT103C 5A # 2" Together with my dear...
@UkBloke As I wrote in another thread, I just understand that everyone is free to make forks and improvements. I also believe that in the case...
Sorry but I don't see the point. Do you mean capacitors on loco to keep power for a while? In my request I asked, in other words, why DCC++,...
@Trusty Thank you, it's clear for me now. But does it means that commercial cs have something like a function register or a loco packet that...
@wvgca Maybe I didn't was too clear. I mean the information sent from the base station to the tracks is repeated every once. In this packet is...
Is there a patch or a code change for DCC++ standard, that a dummy like me can utilize, to make loco lights still on when they loose contact for a...
I got this at one point too. Even alternate flashing of MAIN leds.
Re downloaded the sketch, Compiled&Uploaded to Uno. No changes in config.h Serial monitor from IDE shows the following: at start <iDCC++ BASE...
After these tests I uploaded the DCC++ classic code to the board and again everything is ok.
@FlightRisk Not using Rocrail for these testings, just Arduino IDE and serial monitor, no tracks connected. Tried 2 situations, 1 with no power...