No, The on track mode works for the Tsunami Genesis for the same CVs and I dont have a program track hooked up.
I have a scale trains GEVO that wont take CV changes. I would like to adjust the acc and decel rates. CV 3 and 4 are the ones to change but no...
I have Athearns Tsunami The 911 first responders edition that was running fine. upon trying to reverse direction it flashed all its lights and...
Well, you are right the package says 6 out puts. I am guessing at this point I will keep what I have and simply adjust it to what works best....
Thank you for your help I will give them a try.
It is the TSU 21 PNEM PN 885009. So we have that going for us.
No problem it is a Genesis SD 60E veterans unit.
Tried to program those cvs but I get the wrong with a square message when I hit the program key. The numbers boards flash with the front ditch...
Here is what I found, the numbers board flash alternately on the rear of the engine. is it possible the dutch lights are a different cv? I didnt...
OK so far you guys have been pretty much on the money. Got the address to take 4 digits got the momentum to work and got the front ditch lights...
Thank you I will give them a view
I dont quite understand all of what is in there. If I could get the address changed to a 4 digit number, set the momentum and get the lights to...
I can not program momentum into as well. I have tried it on the main and a programming track with zero success. I have been able to speed match it...
It has leds, when I did the factory reset the ditch lights flashed. I will try your suggestion and see what happens. Im using digitax
Directly trough the CVs I did a factory reset on Tuesday and started over with the same results. THe ditch lights did flash when I did the reset...
Some of the dump trucks and earth moving vehicles are closer to HO than the cars.
I replaced a non sound board with a new Tsunami II in an athearns loco and can only get a couple functions to work. I cannot give it a 4 number...
Thanks I will give vmid a try.
Turning vmax down to 150 worked well. It is only slightly faster than the scale trains at a setting of 25. they run pretty equal up to 10. Thank you.
ok that said I can turn down the top speed (vmax), will that cut the voltage all the way down the dial by the same percent it gets reduced from 255?