It appears the chassis halves were not completely squeezed close enough, so there was a small gap due to when I had to shove a snipped old board...
Just came across this thread on accident. I have one SD40T-2 Southern Pacific. I installed using the older loksound 73100 ( since this was the...
I finally got around to installing an ESU Nano in my Southern Pacific MP15DC. Now I'm getting a good amount of grinding and hesitation. I must...
no specific commodity. Just ones that look and run great. The Atlas 17,600 gallon and 25,500 are the best tank car's I've seen.
As close as the real thing for me. :) I don't usually pay attention to all the very small details like correct decals or the horn is in the...
Anyone able to decipher which tank cars are the best? Almost all my freight cars are Micro Trains, but I got rid of all the 56' tank cars due to...
Anyone familiar with diagnosing the 73199 or similar? I went to add a rear LED and resolder some high points to bring the shell down for my...
Yep. Both of these are the "Classic" Atlas standard dc engines and I used the loksound select direct 73199. I painted the handrails on one of...
[MEDIA]
Yes sir. I place all of my custom-built speaker enclosures in the back top of the chassis. I usually need to shave off some of the rear plastic...
Zero milling.
I got lucky and found a 73100 :).
Upgraded to Kato low profile wheels. Custom lighting and speaker enclosure. Loksound select direct. [MEDIA]
I finally got my hands on a tunnel motor. Noisy and a bit choppy. I read somewhere that it's a good idea to swap out the wheel sets with Kato...
Gotcha. Should it not be checked? When I look at my function mapping for example it still hasn't changed.
Yikes. I was fortunate with my Kato SD40-2. I popped in the new lok 5 after re-soldering the contacts. The body shell must also be wider...
[MEDIA] Kato Loksound 5
It's a Gold Atlas and came pre-downloaded. Which check box are you referring to? [ATTACH]
Agreed. No need for filing down the inside shell as before. Please post once you've completed an install. I've got a good handle on installing...
I'm trying to do a factory reset for an ESU decoder and I'm having no luck. I'll read the decoder and then write a value of 8 for CV08, which...
