Code 80
John, Thanks. DMK
The PECO turnouts are far better than the Atlas ones but I am starting to see several Bachmann steam engines derailing at the points and frogs. T...
Out of box, first run, the front tender truck fell off. It appears to have been repaired before because the plastic center strut was broken....
Lowest price and where? DMJ
Has anyone purchased this engine? If so, how does it run? DMK
Is this dielectric grease? How do you apply it? Thanks, DMK
Have replaced all turnouts with PECO N insulfrog. Tips for where to add wire feeders and rail gaps? DMK
Could you point out where to locate feeders and rail gaps when using PECO N insulfrog or electrofrog turnouts? DMK
All good points. I still prefer the PECO over Atlas. DMK
I was thinking of first cleaning the points with a Q-tip and track cleaner, followed with a dab of dielectric grease? DMK
Now that I have converted all of my Atlas turnouts to PECO, to supposedly solve my "picking the points" derailment issues, now I am encountered...
I have a Model Power Pennsy 2-8-2. I'll set this one aside or contact Bachmann for parts. DMK
The wheel linkage on the right side of my engine separated and I would like to consider repairing it. However, I do not see a listing for the N...
Thanks guys
Basically new, light lights but engine does not run. cleaned track and wheels
Yes, using N Code 80. I have seen that trick and will further investigate it. Thanks, DMK
The apparent short that I recently reported was caused by loose rail joiners creating a high resistance and transformer overload. I replaced most...
Does this site have one? DMK