Walthers Al’s Victory Service Station HO Scale Retails for $34.98 USD. This kit would be suitable for any layout between mid 60’s - early 80’s....
Walthers Silver Spring Bus Station HO Scale Retails for $46.98 USD + shipping new. This kit would be suitable for any layout between mid 60’s...
I don’t know if you’re pulling freight or passenger cars with your F7 but I also replaced the front coupler of every Kato passenger car set with...
I switched out plastic axle wheels on the Walthers El Capitan set when I was running HO for the same reason never had an issue with the...
I’ve had a few out of gauge and recently one ‘loosened’ and caused the baggage car to run slow. Plus I just don’t like plastic axles. I’d rather...
Hey the Microtrains couplers are great (you can find the right ones on their website, they have a chart) but when you couple multiple F units they...
Has anyone swapped out the Kato wheels with the plastic axle on the streamlined names trains? I’m thinking of going with Eastern Seaboard or...
Sounds good. Hopefully they stick to that May time frame. N scale is seriously lacking for bridges, deck girders etc. I hope they at least start...
What’s with Micro Engineering? Have they gone belly up? Anyone know if they are actually taking orders their stuff seemes to be in short supply...
Hello, Does anyone know if the guy who runs the Train Cat website is still with us or at all operational. I was looking to model the Santa Fe...
I’ve got a Kato F7 that came in DC/ DCC compatible when I bought it new. I replaced the DC board with a WVD DCC board and an ESU Lok Sound (58820)...
Thank you for all the advice. I dropped the decoder in and my atlas SD24 is running fast and quiet. I’m currently just breaking it in at our club...
Scaletrains tech support called and were helpful. They gave me a few options. There is a access panel to the decoder under one of the wheel sets...
Thanks for the reply’s. I’m getting ready to install, I just want to make sure the Kapton tape that comes on the decoder from the factory gets...
I’ve got a DCC digitrax board to drop in to a DCC ready atlas SD24. Every time I’ve dropped a board into a DCC ready locomotive there has always...
I will have another look I didn’t see it.
Has anyone attempted to take apart a Scale Trains N scale turbine tender. Mine is way too light and any minor track issue at our club causes it to...
I just got my Scale Trains Big blow Turbine in N Scale and I find the fuel tender doesn’t want to roll freely. There seems to be a lot of...
Both motors seem to run really smooth just something is getting lost in power transfer to the wheels. I’ve looked into a bit more and I’m...
I just purchased some new ones I will let you know.