I don't know that FVM offers (offered?) plastic wheelsets. Regarding ER cars - I have a pile of their Autoflood II hoppers and after months of...
Maybe just a tiny bit... here's a few images: [ATTACH] [ATTACH] [ATTACH]
Fusion: very powerful program. I started using it years ago with my first design and the two designs I was working on yesterday were in... Fusion....
Evening all - figured I'd post a few designs that I have recently uploaded. First one is a 40m wind turbine blade, found here: 1:160 40m Wind...
Last few days have been mostly painting various items. [ATTACH]
I've not yet gotten around to painting the most recent 20' containers uploaded by @Stephane Savard so here's an image of one of the earlier...
Reworking those handrails is going to be fun... it's a beautiful model but there are a few hiccups like the electrical cabling between the front...
Due to the structural differences between the 40' and 48', it will be a challenge. It'd probably be easier to take the 53', cut the ends off, and...
As it sits this morning: finally got around to painting some all terrain cranes I printed early this year, a HEMTT will get into the paint queue...
Elegoo 8k space gray in a Saturn 2. Tried their water washable, didn't like it.
It may also be known as resin Kraft paper, which pretty much describes it: paper soaked in some sort of resin. Apparently it can be sourced in...
Unfortunately I don’t have a Canadian supplier. I mostly use laserboard of varying thicknesses from here: https://encompass-media.salesvu.com/...
From this morning, through the magnifying glass, annotated... taken whilst working on a pair of MTL 2003 for installation in a Kato SD70M. [ATTACH]
A while back I uploaded 3d printable turrets on Thingiverse: 1:160 N Scale turrets by samusi01 - Thingiverse which you may find to be of interest.
Perhaps it might be something to consider on the TrainBoard level to add a directory to the resource section listing folks with resin printers and...
Daily use, ex Frisco main over the Arkansas here in Tulsa. I cropped the original image: [ATTACH]
Not to hijack this too badly, but here's what I've done thus far, for a local who is working on an NTrak module. Here's an image of the original:...
Nice work. Eventually I'll have to figure out an easy way to do stone or concrete blocks in Fusion... my only attempt to date was far more work...
@railtwister Did you note @Joe D'Amato from Micro Trains responding a couple of days ago in this thread? Has he responded to any communication...
In fairness, they do give build dates of mid 1960s and later in the article 1979 for the truncated SD50s that went to the KCS and were also -...