It's beautiful.
Hi folks, just a quick update on my train stuff. [MEDIA]
Yet another project moving along. This is my version of the WiTcontroller. I want to thank Peter Akers and Sumner for this very interesting...
A1 IS ON RECALL! It appears some of the units were shipped with faulty cables causing hot-bed issues.
Sumner, the diesel house is just plain 'big'. I was working on the house as a model, but I wasn't satisfied with the seams, so I decided to mod...
OK, so a slight delay in the reprint of my diesel engine house. I wanted to start it Friday night and have it wrap up by Saturday afternoon, but I...
I have been starting to put some effort into Arduino and I am having a lot of fun, but I do suffer a draw-back, my old brain has a bit of trouble...
I've been tossing around some ideas for a sketch to control a turnout and a couple of lights, actual a total of 4 LED's. Right now, I am...
Yes, my thought was the effort would outweigh the results. Thanks for the quick reply.
Right now it 7.5 deep 5.5 wide and 4.125 tall. Final print will be 8" deep x 6" wide and will remain 4.125 tall. I am hoping to get a final this...
Has anyone tried printing chain-link fence in n-scale using PLA? If so, have you had successes?
I was able to save the shell for the most part, but I will be giving it a reprint starting Friday night. The entire print is 26 hours. [img]
I went into Prusa and totally moded my file. I printed the entire shell of the diesel house. I made a few mistakes in my mod such as forgetting...
OK, so it just wasn't my night. I solved my initial problem, and everything was running great until my PLA sensor decided to misfire and through...
I was running the foundation for a Diesel House project. Ran into some sticky issues. Upper left corner started to curl. I noticed it at the 30%...
OK, the problem is identified and nearly resolved to where I will call it acceptable. I have not releveled my bed since replacing the power...
Those look exactly like mine. I cannot get a clean print on mine. The files I have were resized to N scale from HO. The first prints where way too...
Another afternoon with mu Kobra 2. I am working on a N scale signal bridge. The prints took 3 minutes each, the clean-up 2 1/2 hours of tedious...
Well, I had a snow-day here in the Chicago area and decided to print a couple of fuel tanks and racks for my yard. These prints will obviously...