Happy to see that you have had some success with the ESP32. If you do not want a separate programming track, you can replace GPIO34 with...
https://dcc-ex.com/reference/tools/diagnostic-d-ack-command.html <D ACK LIMIT 50> <D ACK MIN 2000> <D ACK MAX 20000> The default values were...
The next version of DCC-EX will provide DC capability. And Engine Driver can be used to switch from DCC to DC, and drive the DC track. Join the...
You might try connecting them both to the same profile at the same time. In preferences, you specify which is the throttle CS, etc. But there...
With DCC++EX, the version is seen in the startup message when using the Arduino serial monitor. It will also be displayed with the <s> status...
Erik. You give me too much credit. I have slept since working with servo turnouts, in the CMRI sketch. I do recall that whatever I did was not...
One solution is to jumper A1 to GND. Or, use <1 MAIN> instead of <1> to turn on power -- which will keep programming track OFF.
The parameter in config.h to define a static IP is applicable to Ethernet; it is not used for WiFi. To get the same IP address each time, reserve...
You are correct. Turnouts. I have 4 power switches: 1. CMRI Arduinos (RS485) and DCC++EX mimic panels (WiFi) 2. RPi3b JMRI and DCC++EX command...
1. @CSX Robert is correct on the circuit I started from. One pin is used from MCP23017, with Darlington transistor to switch Red LED to GND. Two...
Refer to the PDF for an example of what the two LogixNG records will show. The momentary pushbutton is a sensor to JMRI. LogixNG 'Always...
Attached are notes on how I used JMRI LogixNG to set turnouts and LEDs on a mimic panel. Momentary contact buttons appear as sensors to JMRI and...
DCC++EX will connect to a household WiFi network. The process to do it: 1. Define SSID and password in config.h 2. Upload the sketch 3. Once...
Perhaps follow these instructions. https://dcc-ex.com/get-started/assembly.html DCC++EX support is available using the discord server link on...
That agrees with what I have experienced. I now use a 9 volt wall wart with barrel connector. Connect the USB for data. Power the Arduino Mega...
This shows how track power is sampled until the overload condition is resolved. DCC++EX will continue to test, doubling the time interval, until...
RE: Item 1. Do not assume the resistors on your board are 1k. Confirm the values. Calibrate prior to connecting to the analog input. While the...
- - - why I noted the problem: I had used this inverter circuit with DCC++. It required updating for DCC++EX. DCC++EX takes an initial current...
The DCC signal, when high, sets IBT_2 pin 1 high and forces pin 2 low. When DCC signal is low, pin 1 is low and pin 2 is high -- provided that...
see this link for a listing of compatible boards: https://dcc-ex.com/reference/hardware/microcontroller-boards.html The additional memory on the...