Good morning all, I am in the process of re-designing my second layout, or should I say designing my second layout and dismantling my first...
I’ve posted a couple of new videos dealing with installing Peco turnouts. The first video demos how to prepare your Peco turnout for installation...
Someone familiar with Tam Valley Octo controller would serve me well here. I am trying to automate a turnout that is running an automated three...
Hi all, I have a few questions about the Atlas z scale turnouts. It's been a while since there was conversation about them. After initial...
Hi I am in the early stages of building a layout and am using Atlas track (which may have been a mistake). As my rolling stock runs over a...
So...I figured the time has come to finally start mocking-up a Staging yard. I bought over 40 Atlas C80 LH/RH remote turnouts back in 2017, and...
model in HO and am having an issue with my Peco curved turnout. I seem to get frequent derailments when switching to the inner passing track. I am...
So far I am a little stumped as to the difference between all the turnouts. I will use either a layout that uses both 24" (048) diameter or 30"...
Hello Guys, Has anyone configured accessory decoder and used with DCC++ Command controller? I have configured one Accessory decoder and...
Are they feasible in this scale, in either DC or DCC? Does anyone have working examples? Thanks in advance.
Can I put frog juicers or switch machines on Rokuhan turnouts? They don't look modifiable and I can't find anything on the internet of anybody...
Hi, A pal of mine recently asked me to help with computerising an OO scale layout. We're using a ZTC DCC controller and JMRI on the computer. The...
First try, Before finished.
Hand-drawing track plans can work fine. But general rules-of-thumb for drawing turnouts may not be accurate enough in areas where many turnouts...