I've been struggling for weeks now trying to get my staging yard geometry to look ok. The track I'm using is Atlas C80 with #6 remote turnouts....
Hello. On the picture below you can see different configurations of rail yards. All configurations, except first one, provides sidings of almost...
The scenery at the rear of this 18 foot module set was done by many of the members. Photo taken at Hiller Aviation Museum Trains and Planes...
We have a smaller secondary yard with scenery that we use for smaller layouts or when we want a second yard. This yard is made up of 3 pairs of 3...
Hi all, I am trying to design a fiddle yard to connect to my small switching layout. It will be build out of 9mm strong plywood. The traverse...
The desire here is for a bit of a yard and some industry switching in 6'X8' in HO with aisles on some sides and an access hole pop-up in the...
Simple end terminal yard allows a train to arrive and the engine to cut off and runaround. Discussed in this thread:...
A yard lead extends the opposite direction from a yard ladder, allowing a switcher to work without fouling the main. Note the crossover that...
As backdrop I made some flat structures
Once seen in MR, I've had the intention to make me the same. Thus I made one on a module and named it after my friend John Van Dock
Ex-N&W SD40-2 6168 leads a short train of ballast cars out for a job not far away.
Late afternoon in Denver at 7th Street yard
Initial configuration of main yard is temporarily tacked down in order to provide the opportunity to allow mock operations for evaluation and...
I had opted to use code 100 track on this layout because I has so many Peco code 100 insulfrog turnouts left over from a previous layout and I had...