Worked in paper mills for 20 years so ask away. It realy depends how detailed you want to be. Simplist would indeed be to basically eliminate...
One other request :) Could you add in (commented out if you want) something like 5 buttons for functions (initially set to F0-F5 but editable)...
Thanks for that. Ya its a ESP32 dev board I had laying around. The rotary encoder is flaky in that the speed on works some of the time but I...
Just an update this thing is still going strong 2.5 years later and we still run it at least weekly. I am about to start building my n layout in...
Way late and just getting back into this. 3d Priniting was consuming my hobbytime recently. Anyway I downloaded and bench tested this and all...
Ya worst case you don't like it and go commercial but it's so cheap to try why not. If you are at all computer/electronics savvy I think you'll...
Again read the full DCC++ EX linked above. Specifically https://dcc-ex.com/advanced-setup/supported-motorboards/IBT_2-motor-board-setup.html...
I have a piSprog (which is basically a Sprog3 on a Pihat) and honestly i will never be without it. It's super tiny and in my pocket I carry...
You won't need to know java. It's a really intuitive and well written program and does make it really nice. If you run into issues post...
Well I guess I would say they all work. The trick if you are on DCC power you need a rectifier then a buck convertor or regulator then a...
@Sumner you are doing some awesome work! I will definitely hit you up for the code etc in a couple months. You also inspired me to get a 3d...
I just bought a 3d printer as well so looking forward to getting back into the wireless throttle. Learning fusion 360 as well. So far really...
Nice, I like it
Correct .1uF sorry about that. And fully agree with everything @BigJake says
I have always put RC terminators on the end of my buses. Super cheap as its 100 ohm 1W resistor and .01uF 50V capacitor between the rails and...
so the answer is you could use the existing for sure with any of the open I/O pins but you will need another motor driver. Personally for how...
Agreed not holding my breathe. These are always risky. This one disappointing as close as it got. There is some history with him here on not...
Good info there. Thanks!
@chadbag. Nice job and 2 questions. Would you mind sharing the Gerber files? And also could you possible link to something that shows the SMD...
